1:Motor brand: ITC brand motor (optional Japan Nissei G3L32N20-CN5TCETN model gear motor.)
2:Grinding ball: 3-5% zirconia high hardness, high wear-resistant ceramic grinding ball, each unit contains 100kg grinding ball.
3:Cylinder body 304 stainless steel, barrel wall thickness 3mm, bottom 10mm, cover 304 stainless steel, thickness 10mm, in line with food hygiene requirements.
4:The frame is made of carbon steel, and the bottom plate is covered with stainless steel plate. The paint surface is sprayed with fluorocarbon paint, the color is light gray.
5:Control system: Taiwan SILING frequency converter, LG contactor, Chint knob switch.
6:Transmission parts: spindle: forged in one piece, quenched and tempered. High-strength special hard sprocket, self-strengthening brand chain.
7:Seal ring: open mold manufacturing, plane thickness of 8mm, plane with 3mm reinforced seal ring.
1.In the closed state, the porcelain ball is running under the drive of roller .by friction between porcelain ball and porcelain ball ,to make tea shattered.
2.Automatic operation panel, digital display of milling time.
3.Stainless steel Damping screw, the ball is brought to higher to down, strengthen the friction between the ball and the ball, effectively improve the grinding efficiency.
4.Use food grade alumina ball, Excellent wearability.
5.The barrel lid groove use O-Rings design, Discharging mouth, use non-toxic silica gel. Make sure that Raw materials will not leak out.
|
Model |
JY-6CSAV20 |
|
Machine dimension(L*W*H) |
135*100*170cm |
|
Capacity(KG/Batch) |
20kg |
|
Motor power |
1.5kW+0.4kW,380V+220V Or customized Japan standard 220V ,3phase |
|
Revolutions per minute(rpm) |
38±5 |
|
Machine weight |
410kg |
1. The ambient temperature of the machine should be around 5-10℃ (used under cold storage conditions).
2. The input amount of grinding balls is 90kg-100kg, and the input amount of tea raw materials is 20kg.
The matcha that is ground for the first time is used as a washing machine tea and cannot be eaten.
3. The frequency of the spindle inverter is 65HZ (do not adjust the panel at ordinary times).
4. The grinding time is about 20 hours each time.
5. Do not grind without material. Empty grinding without material will cause the grinding ball to be scrapped!
6. When cleaning the grinding ball, rinse it with water and then dry or dry it. It cannot be soaked or cleaned with alcohol.
7. The chain is added once every 2 days or so, a small amount, and the chain does not dry.
8. Add grease to the spindle bearing every three months.
